Windows | Games | Mobile | Wallpapers


Dielectric Test 1.0

Software that Records test parameters and loads them via an IEEE interface.


Last Week downloads: 0
Total downloads: 283
  • Last Updated: Jan 13, 2013
  • License: Freeware Free
  • OS: Windows 7/Vista/2003/XP/2000/98
  • Requirements: No special requirements

User reviews

4 out of 5 based on 1 ratings for Dielectric Test 1.0

For Dielectric Test 1.0Publisher's description


Dielectric Test is a Home & Education software developed by Gordon Reynolds. After our trial and test, the software is proved to be official, secure and free. Here is the official description for Dielectric Test:

Dielectric Test Program Guide

Tested Windows 7/Vista/98/95

32 and 64 bit Operating Systems

This Software may be freely downloaded
Please Copy source and setup files to a folder and run Setup from there to install software.

Disclaimer :
Neither the suppliers nor the publisher shall accept responsibility for any losses or damage resulting from use of this software, including any loss of profit, damage to Equipment, interruption of business or data or any other damage direct or accidental.
Software includes Visual Basic 6 Source Code.

Software that Records test parameters and loads them via an IEEE interface.
Dielectric Test Guide
This Dielectric Test software was written to create download and store test parameters required for the testing of insulation using a
Sefelec Dielectric unit to test ground continuity and current leakage.
Programm download in this version is effected via a IEEE card interface.
Up to 3 Test units may be controlled via the software and setting the Primary Address of Device.

The Card Installed tick box top left corner should be set if IEEE card is fitted to PC and Dielectric Test unit Connected.

Test Programmes to load are selected via the right hand window.

The software can be in either programmer or OperaTor mode.

In programmer mode Command lines 1 and 2 can be changed and test programmes added or deleted.

In Operator Mode Programmes to load and the interface may be chosen but test parameters cannot be altered.

Selecting the Operator / Programmer button alternates the the user between Operator and programmer by the use of a password.

Initial password set to password.

In this mode the password may be changed Via Change Password.
Tests may be added or Deleted via the Add/Find and Delete buttons.

Data loaded to the test unit via the IEEE card is entered into Commands
Lines 1 and 2.

The Test Instructions field is intended for user test guidence comments.
you can free download Dielectric Test 1.0 now.

For Dielectric Test 1.0Related Software


Please be aware that Brothersoft do not supply any crack, patches, serial numbers or keygen for Dielectric Test,and please consult directly with program authors for any problem with Dielectric Test.